Luch Research & Production Association, R&D Institute, Podolsk, Russia:

A. V. Bratsuk, Category 2 Process Engineer, e-mail: AVBratsuk@mail.ru
S. Yu. Kovtun, Process Engineer, e-mail: Semion-Kovtun@yandex.ru
D. A. Bezzhovchiy, Process Engineer, e-mail: DBezzhovchiy@gmail.com
E. N. Fedorov, Principal Researcher, e-mail: FedorovEN@sialuch.ru

In recent decades, nanotechnology has developed rapidly. Nanotechnology makes the basis for various microelectronic devices that use micro- or milliwatt power. Betavoltaic batteries can serve as power generators of such order. They are combined sets of betavoltaic cells (BVC) based on long-live isotopes and semiconductor converters. This paper considers the use of nickel-63 — an isotope with a half-life of 100.1 years and an average beta-particle energy of 17.4 keV – as a betaradiation source for single BVCs. The advantages of using nickel-63 include safety, technological adaptability, and purity. It emits soft beta-radiation, which does not create critical defects in semiconductors. Titanium dioxide, which is an n-type semiconductor and has high radiation resistance, was used as a semiconductor converter. Titanium dioxide has a relatively wide band gap (3.0 eV for anatase) and can easily develop its surface through common electrochemical anodizing process. The combination of developed structure and a wide band gap will increase the probability of creating a high power density BVC. The authors of this paper synthesized and modified the vertically aligned TiO₂ nanotube arrays and used them to develop a slim prototype BVC using a 20% enriched nickel-63 isotope. Having the dimensions of 20 mm × 20 mm × (15–17) μm, the resulting BVC has an open-circuit voltage of 0.3 V and a short-circuit current density of 0.35 nA/cm². Such electrical characteristics in combination with very small dimensions can potentially lead to the development of a betavoltaic battery with increased power density.
The authors would like to thank Aleksey S. Shadskiy and German L. Ilyichev, who were first to engage in betavoltaic studies at Luch; Dmitry A. Zaytsev for conducting an X-ray phase analysis; Dmitry S. Kiselev for conducting a SEM study; Aleksandra A. Igonina for her su pport with preparation work; Ivan E. Galev and Andrey A. Mokrushin for their creativity and organizational support.
This research was carried out as part of Rosatom’s Single Industry-Specific Plan: Developing a Radioisotope Power Module for Periodically Activated Electronic Devices.

1. Peighambardoust N. S., Asl Shahin K., Mohammadpour R., Asl Shahad K. Improved efficiency in front-side illuminated dye sensitized solar cells based on free-standing one-dimensional TiO₂ nanotube array electrodes. Solar Energy. 2019. Vol. 184. pp. 115–126.
2. Shabanov N. S., Isaev A. B., Orudzhev F. F., Murliev E. K. Sunlight conversion in dye-sensitized solar cells made with cobalt and yttrium doped TiO₂ nanotubes. Pisma v ZhTF. 2018. Vol. 44, No. 2. pp. 42–47.
3. Lashkov A. V., Fedorov F. S., Vasilkov M. Y., Kochetkov A. V. et al. The Ti wire functionalized with inherent TiO₂ nanotubes by anodization as oneelectrode gas sensor: A proof-of-concept study. Sensors and Actuators B: Chemical. 2020. Vol. 306. p. 127615.
4. Abe H., Kimura Y., Ma T., Tadaki D. et al. Response characteristics of a highly sensitive gas sensor using a titanium oxide nanotube film decorated with platinum nanoparticles. Sensors and Actuators B: Chemical. 2020. Vol. 321. p. 128525.
5. Zhou J., Guo M., Wang L., Ding Y. et al. 1T-MoS₂ nanosheets confined among TiO₂ nanotube arrays for high performance supercapacitor. Chemical Engineering Journal. 2019. Vol. 366. pp. 163–171.
6. Bratsuk A. V., Bezzhovchiy D. A., Kovtun S. Y., Kiselev D. S. et al. Development of a betavoltaic cell based on TiO₂ nanotubes and radioisotope Ni63. Conference of Russian Young Researchers in Electrical and Electronic Engineering. IEEE. 2022. pp. 938–941.
7. Ma Y., Wang N., Chen J., Chen C. et al. Betavoltaic enhancement using defect-engineered TiO₂ nanotube arrays through electrochemical reduction in organic electrolytes. ACS Applied Materials & Interfaces. 2018. Vol. 10, No. 26. pp. 22174–22181.
8. Zhang Q., Chen R., San H., Liu G. et al. Betavoltaic microbatteries using TiO₂ nanotube arrays, 2015 Transducers – 2015. 18^th International Conference on Solid-State Sensors, Actuators and Microsystems (TRANSDUCERS), New York. IEEE. pp. 1909–1912.
9. Chen C., Wang N., Zhou P., San H. et al. Electrochemically reduced graphene oxide on well-aligned titanium dioxide nanotube arrays for betavoltaic enhancement. ACS Applied Materials & Interfaces. 2016. Vol. 8, No. 37. pp. 24638–24644.
10. Krasnov A. A., Legotin S. A. Advances in the development of betavoltaic power sources (A review). Pribory i tekhnika eksperimenta. 2020. No. 4. pp. 5–22.
11. Ge M. Z., Cao C. Y., Huang J. Y., Li S. H. et al. Synthesis, modification, and photo/photoelectrocatalytic degradation applications of TiO₂ nanotube arrays: a review. Nanotechnology Reviews. 2016. Vol. 5, No. 1. pp. 75–112.
12. Mor G. K., Varghese O. K., Paulose M., Shankar K. et al. A review on highly ordered, vertically oriented TiO2 nanotube arrays: Fabrication, material properties, and solar energy applications. Solar Energy Materials and Solar Cells. 2006. Vol. 90, No. 14. pp. 2011–2075.
13. Chen Q., Xu D. Large-scale, noncurling, and free-standing crystallized TiO₂ nanotube arrays for dye-sensitized solar cells. The Journal of Physical Chemistry C. 2009. Vol. 113, No. 15. pp. 6310–6314.
14. Fang D. et al. Effect of heat treatment on morphology, crystalline structure and photocatalysis properties of TiO₂ nanotubes on Ti substrate and freestanding membrane. Applied Surface Science. 2011. Vol. 257, No. 15. pp. 6451–6461.
15. CITY LABS: A catalogue of current City Labs products. Available at: https://citylabs.net/products/.
16. Baranov N. N., Mandrugin A. A. A novel multifunctional power source with a record continuous run. Izvestiya Rossiyskoy akademii nauk. Energetika. 2019. No. 1. pp. 82–99.