Journals →  Obogashchenie Rud →  2021 →  #2 →  Back

COMPLEX RAW MATIREAL UTILIZATION
ArticleName Study of the peculiarities of the leaching process for self-crumbling limestone-kaolin cakes
DOI 10.17580/or.2021.02.05
ArticleAuthor Eldeeb A. B., Brichkin V. N., Kurtenkov R. V., Boromotov I. S.
ArticleAuthorData

Saint Petersburg Mining University (St. Petersburg, Russia):

Eldeeb A. B., Postgraduate Student, s175000@stud.spmi.ru
Brichkin V. N., Head of Chair, Doctor of Engineering Sciences, Brichkin_VN@pers.spmi.ru
Kurtenkov R. V., Assistent, Candidate of Engineering Sciences, Kurtenkov.RV@ pers.spmi.ru
Bormotov I. S., Postgraduate Student, s182298@stud.spmi.ru, met@spmi.ru

Abstract

The article presents the results of an experimental study to establish the leaching indicators for limestone-kaolin cakes conducted using soda solutions with various process parameters. The experiments use the mathematical planning method that allows assessing the significance of various cake leaching parameters with the minimum number of experiments. It is shown that the temperature and concentration of the soda solution have a significant effect on the aluminum oxide recovery, with the highest recovery of 79.5 % within the selected factor variation intervals achieved at the process temperature of 50 °C, the soda solution concentration of 100 g/l, the liquid/solid ratio in the slurry of 7, and the leaching time of 25 minutes. Further studies using the coordinate-wise optimization method allowed establishing the leaching process parameters that ensure the aluminum oxide recovery of up to 85.2 %. At the same time, the paper shows a significant effect of the process temperature and time on the depth of secondary interactions leading to the deposition of aluminum oxide and requiring additional systemic studies. The established chemical and material composition of the sludge suggests that it may be effectively used as a component in raw Portland cement mixes, as well as a raw material for the regeneration and recycling of the lime component, which would reduce the consumption of natural carbonate raw materials and cut the emissions of greenhouse gases into the atmosphere.
The research was carried out with the use of the laboratory equipment of the Scientific and Educational Center for Shared Use of the St. Petersburg Mining University.
The work was carried out with the financial support of the Russian Science Foundation under the Agreement No. 18-19-00577 of April 26 2018 of grant for fundamental scientific research and exploratory scientific research.

keywords Kaolin ore, leaching, mathematical planning, process parameters, aluminum oxide recovery, coordinate-wise optimization
References

1. Sizyakov V. M. Mining Institute and problems of the development of the aluminum industry in Russia. Zapiski Gornogo Instituta. 2005. Vol. 165. pp. 163–169.
2. Cohen J., Mercier H. Recovery of alumina from nonbauxite aluminum-bearing raw materials. Essential readings in light metals. Springer, 2016. pp. 1057–1064.
3. Tian Y., Pan X., Yu H., Han Y., Tu G., Bi S. An improved lime sinter process to produce Al2O3 from low-grade Al-containing resources. Light metals. Springer, 2016. pp. 5–9.
4. Guo Y., Yan K., Cui L., Cheng F. Improved extraction of alumina from coal gangue by surface mechanically grinding modification. Powder Technology. 2016. No. 302. pp. 33–41.
5. Dubovikov O. A., Yaskelyaynen E. E. Processing of lowquality bauxite feedstock by thermochemistry–Bayer method. Zapiski Gornogo Instituta. 2016. Vol. 221. pp. 668–674.
6. Arsentyev V. A., Gerasimov A. M., Mezenin A. O. Kaolines beneficiation technology study with application of hydrothermal modification. Obogashchenie Rud. 2017. No. 2. pp. 3–9. DOI: 10.17580/or.2017.02.01.
7. Adeoye J. B., Omoleye J. A., Ojewumi M. E. Development of alum from kaolin deposit using response surface methodology. MOJ Bioorganic & Organic Chemistry. 2018. Vol. 2, Iss. 3. pp. 166–169.
8. Suss A. G., Damaskin A. A., Senyuta A. S., Panov A. V., Smirnov A. A. The influence of the mineral composition of low grade aluminum ores on aluminium extraction by acid leaching. Light metals. 2014. pp. 105–109.
9. Pak V. I., Kirov S. S., Nalivaiko A. Y., Ozherelkov D. Y., Gromov A. A. Obtaining alumina from kaolin clay via aluminum chloride. Materials. 2019. Vol. 12, No. 23. 12 p. DOI: 10.3390/ma12233938.
10. Miao L., Ji G., Gao G., Li G., Gan S. Extraction of alumina powders from the oil shale ash by hydrometallurgical technology. Powder Technology. 2011. Vol. 207, No. 1–3. pp. 343–347.
11. Gao Y., Liang K., Gou Y., Wei S., Shen W., Cheng F. Aluminum extraction technologies from high aluminum fly ash. Reviews in Chemical Engineering. 2020. February 14. 22 p. DOI: 10.1515/revce-2019-0032.
12. ElDeeb A. B., Brichkin V. N., Povarov V. G., Kurtenkov R. V. The activating effect of carbon during sintering the limestone-kaolin mixture. Tsvetnye Metally. 2020. No. 7. pp. 18–25. DOI: 10.17580/tsm.2020.07.02.
13. Yan K., Guo Y., Fang L., Cui L., Cheng F., Li T. Decomposition and phase transformation mechanism of kaolinite calcined with sodium carbonate. Applied Clay Science. 2017. Vol. 147. pp. 90–96.
14. Sizyakova E. V., Fokina S. B., Ivanov P. V. Influence of carbon-containing additives on sintering of limestonenepheline furnace charge in alumina production. Journal of Physics: Conference Series. 2019. Vol. 1399, Iss. 5. Article 055042.
15. Al-Ajeel A. A., Abdullah S. Z., Muslim W. A., Abdulkhader M. Q., Al-Halbosy M. K., Al-Jumely F. A. Extraction of alumina from Iraqi colored kaolin by lime-sinter process. Iraqi Bulletin of Geology and Mining. 2014. Vol. 10, No. 3. pp. 109–117.
16. Guo Y., Yan K., Cui L., Cheng F., Lou H. H. Effect of Na2CO3 additive on the activation of coal gangue for alumina extraction. International Journal of Mineral Processing. 2014. No. 131. pp. 51–57.
17. Sizyakov V. M. Chemical and technological mechanisms of a alkaline aluminum silicates sintering and a hydrochemical sinter processing. Zapiski Gornogo Instituta. 2016. Vol. 217. pp. 102–112.
18. Toama H. Z., Al-Ajeel A. A., Jumaah A. H. Studying the efficiency of lime-soda sinter process to extract alumina from colored kaolinite ores using factorial technique of design of experiments. Engineering and Technology Journal. 2018. Vol. 36, Pt. A, No. 5. pp. 500–508.
19. Azof F. I., Yang Y., Panias D., Kolbeinsen L., Safarian J. Leaching characteristics and mechanism of the synthetic calcium-aluminate slags for alumina recovery. Hydrometallurgy. 2019. Vol. 185. pp. 273–290.
20. Ptáček P., Opravil T., Šoukal F., Havlica J., Holešinský R. Kinetics and mechanism of formation of gehlenite, Al–Si spinel and anorthite from the mixture of kaolinite and calcite. Solid State Sciences. 2013. Vol. 26. pp. 53–58.
21. Alekseev A. I., Kononchuk O. O., Goncharova M. V., Hippmann S., Bertau M. Recovery of CaCO3 from the nepheline sludge of alumina production. Chemie-Ingenieur-Technik. 2019. No. 4. pp. 1–9.
22. Abdelalim A. M. K., Ghorab H. Y., Abdelaziz G. E., Elsayed M. S. Dealuminated kaolin as cement replacement material. Cement, Wapno, Beton. 2008. Vol. 15, No. 3. pp. 132–140.
23. Siziakova E. V., Ivanov P. V., Boikov A. V. Hydrocarboaliminate calcium application in aluminum processing for production of special cement brands. Journal of Physics: Conference Series. 2018. Vol. 1118, Iss. 1. Article 012018.

Language of full-text russian
Full content Buy
Back