Gipronikel Institute LLC, Saint Petersburg, Russia:

A. V. Trofimov, Head of the Centre, Candidate of Technical Sciences, e-mail: trofimovav@nornik.ru
A. E. Rumyantsev, Lead Researcher, Candidate of Technical Sciences, e-mail: rumyantsevae@nornik.ru

Saint Petersburg Mining University, Saint Petersburg, Russia:
A. P. Gospodarikov, Professor, Doctor of Technical Sciences, e-mail: kafmatem@spmi.ru

Gipronikel Institute LLC, Saint Petersburg, Russia¹ ; Saint Petersburg Mining University, Saint Petersburg, Russia²:
A. P. Kirkin, Junior Researcher¹, Postgraduate Student², e-mail: alexkirkin2011@gmail.com

In underground mining with backfilling of mined-out areas, it is necessary to analyze the filling mass quality. Since coring and testing would make a complex process, the method of express analysis comes in handy. As the mechanical methods of express quality analysis are not very accurate, the best option would be to use an acoustic method. But before the latter can be used, it is necessary to conduct a series of laboratory tests in order to under stand the empirical correlation between strength and acoustic pro perties. This paper describes the results of laboratory tests that were carried out for samples of backfill concrete after 7, 28, 45, 70, 90 days of curing to test their strength and acoustic properties. A correlation has been found between the uniaxial compressive strength of the fill and the ultrasonic wave propagation rates. Some field measurements have been taken to determine the propagation rates of longitudinal and transverse waves in the filling mass. Calibration curves have been built for both longitudinal and transverse waves. It was established that for the filling mass that hasn’t cured for 90 days it is the propagation rate of transverse waves that correlates most accurately with the strength; whereas for the filling mass that is older than 90 days it is the propagation rate of longitudinal waves.

1. Golik V. I., Lukianov V. G. Strength optimization of the backfill material accounting for the rock stress level. Izvestiya Tomskogo politekhnicheskogo universiteta. Inzhiniring georesursov. 2016. Vol. 327, No. 6. pp. 6–14.
2. Komurlu E., Kesimal A. Sulfide-rich mine tailings usage for short-term support purposes: An experimental study on paste backfill barricades. Geomechanics and Engineering. 2015. Vol. 9, Iss. 2. pp. 195–205.
3. Marysyuk V. P., Darbinyan T. P., Andreev A. A., Noskov V. A. Analyzing the efficiency of changing the development system for mining of copper-nickel sulphide ores at the Oktyabrsky Mine. Gornyi Zhurnal. 2019. No. 11. pp. 19–23.
4. Vasilyeva M. A. Magnetic peristatic pumps for backfill. Eurasian Mining. 2019. No. 1. pp. 34–36. DOI: 10.17580/em.2019.01.08.
5. Voronov E. T., Tyupin V. N. Substantiation of strength of filling mass by taking a blast effect into account for the room-and-pillar methods. Journal of Mining Institute. 2018. Vol. 229. pp. 22–26. DOI: 10.25515/PMI.2018.1.
6. Shaposhnik Yu. N., Shaposhnik S. N. Feasible backfilling methods for Kazzinc’s underground mines. Vestnik Rossiiskogo Universiteta Druzhby Narodov. Seriya: Inzhenernye Issledovaniya. 2009. No. 3. pp. 72–78.

7. Rubchevskiy Yu. I. The practice of using non-destructive methods for testing the backfilling mass at the Yakovlevsky mine. Estestvennye i tekhnicheskie nauki. 2015. No. 3. pp. 86–93.
8. Potapov A. I., Kondratev A. V. Non-destructive testing of multilayer medium by the method of velocity of elastic waves hodograph. Journal of Mining Institute. 2020. Vol. 243. pp. 348–356. DOI: 10.31897/PMI.2020.3.348.
9. Rajaoalison H., Zlotkowski A., Rambolamanana G. Mechanical properties of sandstone using non-destructive method. Journal of Mining Institute. 2020. Vol. 241. pp. 113–117. DOI: 10.31897/PMI.2020.1.1133.
10. GOST 17624–2012. Concrete. Ultrasonic method of strength determination. Introduced: 01.01.2014.
11. Sinyakin K. G. Determining the strength of the backfilling material at the Yakovlevsky iron ore mine. Zapiski Gornogo instituta. 2011. Vol. 189. pp. 248– 251.
12. Xu S., Suorineni F. T., Li K., Li Y. Evaluation of the strength and ultrasonic properties of foam-cemented paste backfill. International Journal of Mining, Reclamation and Environment. 2017. Vol. 31, Iss. 8. pp. 544–557.
13. Jiang H., Han J., Li Y., Yilmaz E. et al. Relationship between ultrasonic pulse velocity and uniaxial compressive strength for cemented paste backfill with alkali-activated slag. Nondestructive Testing and Evaluation. 2020. Vol. 35, Iss. 4. pp. 359–377.
14. Feng G., Du X., Zhand Y. Optical-acoustic-stress responses in failure progress of cemented gangue-fly ash backfill material under uniaxial compression. Nondestructive Testing and Evaluation. 2019. Vol. 34, Iss. 2. pp. 135–146.
15. Du X., Feng G., Zhang Y., Wang Z. et al. Bearing mechanism and stability monitoring of cemented gangue-fly ash backfill column with stirrups in partial backfill engineering. Engineering Structures. 2019. Vol. 188. pp. 603–612.
16. Xu W., Li Q., Liu B. Coupled effect of curing temperature and age on compressive behavior, microstructure and ultrasonic properties of cemented tailings backfill. Construction and Building Materials. 2020. Vol. 237. Article 117738.
17. Wu J., Jing H., Yin Q., Yu L. et al. Strength prediction model considering material, ultrasonic and stress of cemented waste rock backfill for recycling gangue. Journal of Cleaner Production. 2020. Vol. 276. Article 123189.
18. Zhu P., Song W., Cao S., Wan F. et al. Tensile mechanical response mechanism of cemented backfills under blasting load. Caikuang yu Anquan Gongcheng Xuebao. Journal of Mining and Safety Engineering. 2018. Vol. 35, Iss. 3. pp. 605–611.
19. Montyanova A. N., Trofimov A. V., Rumyantsev A. E., Vilchinskiy V. B. Development and pilot testing of plasticized backfill material at the mines of Norilsk Nickel’s Polar Branch. Gornyi Zhurnal. 2019. No. 11. pp. 28–32.
20. GOST 21153.7–75. Rocks. Method for determining the propagation rates of longitudinal and transverse elastic waves. Introduced: 30.06.1976.
21. GOST 10180–12. Concretes. Methods for strength determination using reference specimens. Introduced: 01.07.2013.
22. GOST 28570–2019. Concretes. Methods of strength determination on cores selected from structures. Introduced: 01.09.2019.