Журналы →  Non-ferrous Metals →  2022 →  №2 →  Назад

Название Semi-industrial technology tests of the sanitary cleaning of metallurgical enterprises waste gases from sulfur and nitrogen oxides
DOI 10.17580/nfm.2022.02.01
Автор Dosmukhamedov N. K., Kaplan V. A.
Информация об авторе

Satbayev University, Almaty, Kazakhstan:

N. K. Dosmukhamedov*, Professor, Department of Metallurgy and Mineral Processing, e-mail: nurdos@bk.ru


Weizmann Institute of Science, Rehovot, Israel:

V. A. Kaplan, Academic Consultant, Department of Material and Interfaces, e-mail: valery.kaplan@weizmann.ac.il

*Correspondence author.


Nitrogen emissions in the form of NOx with flue gases from thermal power plants are the most serious pollutants generated during the combustion of coal. The calcium carbonate gas scrubbing process used today is expensive, generates a lot of waste, and leaves a significant amount of SO2 in the gas. Virtually no NOx removal. In this paper, we consider the behavior of nitrogen oxides during the purification of exhaust gases from thermal power plants with a carbonate melt of alkali metals. Based on the thermodynamic analysis of reactions between NOx and alkali metal carbonates, the possibility of reducing their concentrations in the exhaust gases is shown. It has been established that the process of NOx absorption in the temperature range of 573…823K is accompanied by the formation of stable potassium nitrite (KNO2) in the melt, as evidenced by the high negative values of the Gibbs energies of the reactions. The results of balance experiments fully confirm the established regularities. One can foresee that carbonate melt-based SO2 removal may become a practical and economical scrubbing method for sulfur-poor flue gases emitted by nonferrous metal production plants, thereby contributing to the limiting of harmful sulfur and NOx emissions into the atmosphere.

The research was carried out within the framework of grant funding of the Science Committee of the Ministry of Education and Science of the Republic of Kazakhstan for 2020–2022 in the priority area “Rational use of natural resources, including water resources, geology, processing, new materials and technologies, safe products and structures” project No. AP08856384 “Development of a new high-tech technology for the utilization of the SOand CO2 from flue gases from thermal power plants and metallurgical plants with the production of marketable products”.

Ключевые слова Flue gases, sulfur dioxide, nitric oxide, chemical absorption, carbonate eutectic, potassium carbonate, potassium nitrite, natural gas, Gibbs energy
Библиографический список

1. Capacity Building Program for Regional Cooperation on the Priority of the Regional Action Plan for Environmental Protection “Air Quality” within the Framework of the CAPACT Project. Tashkent, 2012. 31 p.
2. Besire C., Mehush A., Tahir M. Measurements of Emission of Gases SO2, NOx, CO and CO2 from the Burning Process in the Furnaces of Power Plant “Kosova B”. Journal of International Environmental Application & Science. 2010. Vol. 5, Iss. 2. pp. 172–174.
3. Gutiérrez Ortiz F. J., Vidal F., Ollero P., Salvador L., Cortés V., Giménez A. Pilot-Plant Technical Assessment of Wet Flue Gas Desulfurization Using Limestone. Industrial & Engineering Chemistry Research. 2006. Vol. 45, Iss. 4. pp. 1466–1477.
4. Zhitao H., Tianyu Z., Junming W., Jingming D., Yangbo D., Xinxiang P. A Novel Method for Simultaneous Removal of NO and SO2 from Marine Exhaust Gas via In-Site Combination of Ozone Oxidation and Wet Scrubbing Absorption. Journal of Marine Science and Engineering. 2020. Vol. 8, Iss. 11. 943. DOI: 10.3390/jmse8110943
5. Hutson N. D., Krzyzynska R., Srivastava R. K. Simultaneous Removal of SO2, NOx, and Hg from Coal Flue Gas Using a NaClO2-Enhanced Wet Scrubber. Industrial & Engineering Chemistry Research. 2008. Vol. 47, Iss. 16. pp. 5825–5831.
6. Crundwell F. K., Moats M. S., Ramachandran V., Robinson T. G., Davenport W. G. Extractive Metallurgy of Nickel, Cobalt and Platinum-Group Metals. Oxford: Elsevier, 2011. 622 p.
7. Davenport W. G., King M., Schlesinger M., Biswas A. K. Extractive Metallurgy of Copper. 4th ed. Oxford: Pergamon, 2002. 432 p.
8. Habashi F. Copper Metallurgy at the Crossroads. Journal of Mining and Metallurgy, Section B: Metallurgy. 2007. Vol. 43, Iss. 1. pp. 1–19.
9. Nolan P. S., Jiang M. X. Flue Gas Desulfurization Technologies for Coal-Fired Power Plants. Coal-Tech 2000 International Conference, Jakarta, Indonesia, November 13–14, 2000.
10. Srivastava R., Jozewicz W. Flue Gas Desulfurization: The State of the Art. Journal of the Air & Waste Management Association. 2001. Vol. 51, Iss. 12. pp. 1676–1688.
11. Dosmukhamedov N., Kaplan V., Zholdasbay E., Wachtel E., Lubomirsky I. Natural Gas Regeneration of Carbonate Melts Following SO2 Capture from Non-ferrous Smelter Emissions. RSC Advances. 2017. Vol. 7, Iss. 35. pp. 21406–21411.
12. Dosmukhamedov N. K., Kaplan V. A., Zholdasbay E. E., Dosmukhamedov D. N., Lubomirsky I. Development of Technology for Cleaning Exhaust Gases of Thermal Coal-Fired Power Plants From Sulfur. Ugol’. 2015. No. 8. pp. 106–110.
13. Turkdogan E. T. Physical Chemistry of High Temperature Technology. 1st ed. New-York: Academic Press, 1980. 447 p.
14. Ibrahim H. G., Okasha A.Y., Elatrash M. S., Al-Meshragi M. A. Investigation of SO2 and NOX Emissions from Khoms Power Stations in Libya. 2012 International Conference on Environmental, Biomedical and Biotechnology (IPCBEE, Vol. 41). IACSIT Press: Singapore, 2012. pp. 191–195.
15. Kakareka S., Kukharchyk T., Krukowskaya O. Opportunities and challenges from the implementation of the Gothenburg Protocol obligations, in the Power Plant Sector in Belarus. Minsk: Institute for Nature Management National Academy of Sciences, 2016. 163 p.
16. Srivastava R. K., Hall R. R., Khan S., Culligan K., Lani B. W. Nitrogen Oxides Emission Control Options for Coal-Fired Electric Utility Boilers. Journal of the Air & Waste Management Association. 2012. Vol. 55, Iss 9. pp. 1367–1388.
17. Taymarov M. A., Akhmetova R. V., Sungatullin R. G., Chiklyaev E. G., Chiklyaev D. E. Education and Ways of Reducing Nitrogen Oxides in the Boiler TG-104 with a Direct-Flow-Vortex burners and the peripheral gas supply. Power Engineering: Research, Equipment, Technology. 2016. No. 9-10. pp. 83–90.
18. Kaplan V., Wachtel E., Dosmukhamedov N., Lubomir sky I. Carbonate Melt-Based Flue Gas Desulfurization: Material Balance and Economic Advantage. International Journal of Oil, Gas and Coal Technology. 2018. Vol. 18, Iss. 1/2. pp. 25–38.
19. Kaplan V., Wachtel E., Lubomirsky I. Carbonate Melt Regeneration for Efficient Capture of SO2 from Coal Combustion. RSC Advances. 2013. Vol. 3, Iss. 36. pp. 15842–15849.
20. Schlesinger M. E., King M. J., Sole K. C., Davenport W. G. Extractive Metallurgy of Copper. 5th ed. Amsterdam: Elsevier, 2011. 472 p.

Полный текст статьи Semi-industrial technology tests of the sanitary cleaning of metallurgical enterprises waste gases from sulfur and nitrogen oxides