NORILSK NICKEL CELEBRATES ITS 85 ANNIVERSARY | |
GEOMECHANICAL STUDIES TO SUPPORT MINERAL MINING | |
Название | Stress assessment ahead of stoping front with widening stress relief zone – A case study of the Oktyabrsky and Talnakh deposits |
DOI | 10.17580/gzh.2020.06.06 |
Автор | Sergunin M. P., Alborov A. E., Andreev A. A., Buslova M. A. |
Информация об авторе | Norilsk Nickel’s Polar Division, Norilsk, Russia: M. P. Sergunin, Head of Department for Geotechnical Engineering Supervision of Mining, Center for Geodynamic Safety
Center for Geomechanics and Mining Practice, Saint-Petersburg State Mining University, Saint-Petersburg, Russia:
The authors appreciate participation of V. P. Marysyuk, Yu. N. Nagovitsin, D. Kh. Gilyazev, A. A. Bazin and V. A. Gorpinchenko in this study. |
Реферат | The Oktyabrsky and Talnakh deposit are classified as rockburst-hazardous at the depths greater than 700 m. Protection of mining areas by stress relief drilling is advantageous for flexibility, low cost and high efficiency. The regulatory requirements set the minimal sizes for the protection zones (advance of the relieving front relative to the stoping front) to maintain the design performance of stoping with regard to safety berms. Optimization of the advance value based on geomechanical parameters is disregarded and unregulated. Purely economically, it is expedient to maintain a minimal advance as the relief drilling cost is the lowest in this case. It is found that widening of a stress relief zone is accompanied by a considerable decrease in the stress concentration factor in the maximum abutment pressure zone. The stress field pattern is the most favorable in this case, and the reduction in the maximal stresses mitigates the risk of events due to strata pressure in the leading development headings. Based on the accomplished analysis, with a view to improving geodynamic safety in rockbursthazardous areas in the test mines, it is recommended to enlarge the width of the stress relief zones above the minimal standard required by the conditions of stoping. |
Ключевые слова | Stress state, protection zone, stress relief zone, stress relief drillholes, core disking, stoping influence zone, increased strata pressure zone |
Библиографический список | 1. Eremenko V. A., Aynbinder I. I., Patskevich P. G., Babkin E. A. Assessment of the state of rocks in underground mines at the Polar Division of Norilsk Nickel. GIAB. 2017. No. 1. pp. 5–17. |
Language of full-text | русский |
Полный текст статьи | Получить |