Журналы →  Non-ferrous Мetals →  2019 →  №2 →  Назад

BENEFICATION
Название Analysis of the reasons for molybdenite losses and improvement of recirculating water conditioning regimes in the process of copper-molybdenum ore flotation
DOI 10.17580/nfm.2019.02.02
Автор Pestryak I. V., Morozov V. V., Tumen-Ayush Batmunkh, Erdenetuya Ochir
Информация об авторе

National University of Science and Technology “MISiS”, Moscow, Russia:

I. V. Pestryak, Ph. D., Acting Chief, Department of General and Inorganic Chemistry, e-mail: spestryak@mail.ru
V. V. Morozov, Ph. D., Prof., Department of General and Inorganic Chemistry, e-mail: dchmggu@mail.ru

 

KOO “Enterprise “Erdenet”, Erdenet, Mongolia:
Tumen-Ayush Batmunkh, Deputy Director General, e-mail: tbatmunkh@erdenetmc.mn
Erdenetuya Ochir, Ph. D., Head of the Department of Occupational and Environmental Protection, e-mail: erdenetuya@erdenetmc.mn

Реферат

Copper-molybdenum ore flotation at closed water circulation system is accompanied by significant losses of molybdenum, recovery of which often does not exceed 50%. The losses are often caused by changing ion composition of the pulp aqueous phase, and primarily accumulation of copper and calcium ions, causing the change in the state of mineral surface. The probability of molybdenite activation by copper cations under conditions of copper-molybdenum ore milling was determined by thermodynamic calculations and confirmed by spectral studies. It was demonstrated that the activation of molybdenite by copper ions increases floatability in the bulk flotation circuit, but causes depression and increase in molybdenite losses in the selective flotation circuit, that leads to decreasing the recovery into commercial concentrates. Kinetic parameters of the interaction of molybdenite with copper cations under milling conditions were experimentally determined, and the boundary concentration of copper cations (0.175 mg/l) was determined. The reasons for molybdenite flotability decline at elevated concentrations of calcium ions and molybdate ions were determined: the formation of calcium molybdate on the mineral surface under conditions of bulk flotation, which is transformed to hydrophilic calcium carbonate at pH above 9.5. The flotation studies established the maximum permissible concentration of copper ions (0.6 mg/l) and calcium (350 mg/l) in recirculating water, exceeding of which leads to deterioration of the process performance. Regime of joint conditioning of filtrates saturated with copper and utility fluids was developed, at the medium pH maintained at 7.5–7.8 by lime adding, providing reducing concentration of dissolved copper and technical fatty acids in the purified recirculating water to 0.4 mg/l and 0.55 mg/l, respectively. The developed conditioning regime for heavily polluted effluents of Erdenet GOK industrial cluster made it possible to increase the recovery of copper and molybdenum by 0.35% and 0.5%, respectively, when the effluents are involved in the water circulation system.

Ключевые слова Copper-molybdenum ores, molybdenite, activation, filtrates, effluents, wastewater, copper and calcium cations, flotation, recirculating water, conditioning
Библиографический список

1. Bajmakhanov M. T. About Water Rotation in Internal-Drainage System at Non-Ferrous Metallurgy Concentrating Plants with Simultaneous Perfection of their Technology. Tsvetnye Metally. 2010. No. 4. pp. 22–25.
2. Castro S., Lopez-Valdivieso A., Laskowski J. S. Review of the Flotation of Molybdenum. Part I: Surface Properties and Floatability. International Journal of Mineral Processing. 2016. Vol. 148. pp. 48–58.
3. Nakhaei F., Irannajad M. Investigation of Effective Parameters for Molybdenum Recovery from Porphyry Copper Ores in Industrial Flotation Circuit. Physicochemical Problems of Mineral Processing. 2014. Vol. 50, Iss. 2. pp. 477–491.
4. Viduetskiy M. G., Garifulin I. F., Maltsev V. A., Purgin A. P. Technology for Cleaning of Mine, Undercut, Circulating and Waste Water in Mining and Metallurgical Enterprises. Tsvetnye Metally. 2017. No. 8. pp. 9–14. DOI: 10.17580/tsm.2017.08.01.
5. Liu W., Moran C. J., Vink S. A Review of the Effect of Water Quality on Flotation. Minerals Engineering. 2013. Vol. 53. pp. 91–100.
6. Morozov V. V., Avdokhin V. M. Beneficiation of Polymetallic Ores Optimized Through Ion Control of Slurry and Recirculation Waters. GIAB. 1998. No. 1. pp. 27–32.
7. Ignatkina V. A., Bocharov V. A., Khachatryan L. S., Baatarhuu J. Flotation of Porphyry Copper-Molybdenum Ores With the Use of Various Collectors and Frothers. GIAB. 2007. No. 7. pp. 321–329.
8. Desyatov A. M., Herson , M. I., Ba atarkhuu Z., Karnaukhov S. N. Perfection of Technology of Enrichment of Copper-Molybdenum Ore Deposits “Erdenetiin Ovoo” (Mongolia) in Terms of Change of Material Composition of Ores. GIAB. 2008. No. 6. pp. 345–349.
9. Castro S. Physico-Chemical Factors in Flotation of Cu – Mo – Fe Ores With Seawater: a Critical Review. Physicochemical Problems of Mineral Processing. 2018. Vol. 54, Iss. 4. pр. 1223–1236.
10. He W., Juanping Q., Tingshu H., Xianzhong B., Wei Y., Hui L. A New Concept on High-Calcium Flotation Wastewater Reuse. Minerals. 2018. Vol. 8, Iss. 11. DOI: 10.3390/min8110496
11. Li B., He L., Meng R., Song J. Research of Acid Mine Wastewater Treatment Technology. Journal of Chemical and Pharmaceutical Research. 2015. Vol. 7, Iss. 4. pp. 1011–1017.
12. Zanin M., Ametov I., Grano S., Zhou L., Skinner W. A Study of Mechanisms Affecting Molybdenum Recovery in a Bulk Copper/Molybdenum Flotation Circuit. International Journal of Mineral Processing. 2009. Vol. 93, Iss. 3-4. pp. 256–266.
13. Abramov A. A. Regularities of Reagents Effect on Properties and Floatability of Copper Minerals with Sulphydrilic Collectors. Part 2. Optimal Conditions of “Collectorless” and Usual Flotation of Copper Minerals. Tsvetnye Metally. 2017. No. 5. pp. 27–32. DOI: 10.17580/tsm.2017.05.04.
14. Delger R., Baatarkhuu J., Tuyaa Ts., Desyatov A. M., Khersonsky M. I. Improvement Schemes and Reagent Regime Copper-Molybdenum Flotation in the Rough Concentrate Finishing Circuit on the Processing Plant “Company of Erdenet”. Tsvetnye Metally. 2012. No. 2. pp. 21–24.
15. Pestryak I. V., Erdenetuyaa O., Morozov V. V. Return Water Improvement at Erdenet Mining Complex. Obogashchenie Rud. 2013. No. 2. pp. 3–8.
16. Pestriak I., Morozov V., Erdenetuya O. Modeling and Development of Recycled Water Conditioning of Copper-Molybdenum Ore Processing. International Journal of Mining Science and Technology. 2019. Vol. 29, Iss. 2. pp. 313–317.
17. Kakovsky I. A., Naboychenko S. S. Thermodynamics and Kinetics of Hydrometallurgical Processes. Alma-Ata: Nauka, 1986. 267 p.
18. Abramov A. A. Flotation. Physical and Chemical Modeling of Processes. Collected Works. Vol. 6. Moscow: Gornaya kniga, 2010. 607 p.
19. Ya shina G. M., Olerskaya H. L. Investigation of the Electrochemical Behavior of Pyrite on the Curves of the Potential Decline. Journal of Mining Sciences. 1979. No. 6. pp. 92–96.
20. Muzafarov A. M., Vasilenok O. P., Narbadalov Sh. I., Sattarov G. S. Assessment of the Possibility of the Off-Spec Water Application in Hydrometallurgical Production. Tsvetnye Metally. 2016. No. 2. pp. 27–32. DOI: 10.17580/tsm.2016.02.04.

Полный текст статьи Analysis of the reasons for molybdenite losses and improvement of recirculating water conditioning regimes in the process of copper-molybdenum ore flotation
Назад