Журналы →  Eurasian mining →  2020 →  №2 →  Назад

PHYSICS OF ROCKS AND PROCESSES
Название Operational control of rib pillar stability
DOI 10.17580/em.2020.02.02
Автор Baryah A. A., Evseev A. V., Lomakin I. S., Tsayukov A. A.
Информация об авторе

Perm Federal Research Center, Ural Branch, Russian Academy of Sciences, Perm, Russia:

Baryah A. A., Director, Doctor of Engineering Sciences, Academician of the Russian Academy of Sciences

 

Mining Institute—Division of the Perm Federal Research Center, Ural Branch, Russian Academy of Sciences, Perm, Russia:
Evseev A. V., Researcher, Candidate of Engineering Sciences, evseev@mi-perm.ru
Lomakin I. S., Researcher, Candidate of Engineering Sciences
Tsayukov A. A., Engineer

Реферат

In room-and-pillar mineral mining, rib pillars should support overlying rock mass for the specified time limit of production. Therefore, one of the mining safety components is monitoring of the behavior of rib pillars in the course of time. For the conditions of the room-andpillar method of mining, the authors propose a monitoring procedure for rib pillar deformation based on operational measurements of horizontal convergence in stopes. The theoretical and experimental research proves that transverse deformation of rib pillars is an informative parameter suitable for generalized assessment of pillar failure. The obtained ranges of critical transverse deformation rates (50–100 mm/m/yr) in rib pillars can tentatively be used as an indicator of the critical stability of load-bearing structures in room-and-pillar mining. In-situ determination of the integral transverse deformation rates in rib pillars is based on the ratio of the measured horizontal convergence in stopes to the width of pillars. Implementation of the proposed approach in the Upper Kama potash salt mines has proved its applicability to identification of rock mass areas where intense deformation is expected. The comparison of the monitoring data of the transverse deformation rates and their critical values determined makes it possible to predict service life of rib pillars, which is very important in terms of safety of mining operations.

This study was supported by the Russian Science Foundation, Grant No. 19-77-30008.

Ключевые слова Room-and-pillar mining system, pillar stability, deformation, control, mathematical modeling
Библиографический список

1. Golasowski J., Vochta R., Hudeček V., Mikoláš M., Dvořák P. Room and pillar mining at OKD, as in the Czech Republic. 14th International Multidisciplinary Scientific Geoconference & Expo SGEM 2014. Albena, Bulgaria, 2014 pp. 529–536.
2. Jong-Gwan Kim, Mahrous A. M. Ali, Hyung-Sik Yang. Robust Design of Pillar Arrangement for Safe Room-and-Pillar Mining Method. Geotechnical and Geological Engineering. 2019. Vol. 3. pp. 1931–1942.
3. Permyakov R. S., Romanov V. S., Beldy M. P. Salt mining technology. Moscow : Nedra, 1981. 272 p.
4. Makarov A. B., Livinsky I. S., Rasskazov I. Y., Saksin B. G., Potapchuk M. I. Geomechanical evaluation of roof-and-pillar parameters in transition to underground mining. Journal of Mining Science. 2016. Vol. 52, No. 3. pp. 438–447.
5. Guidelines for mine flooding protection and safety of undermined facilities in the Upper Kama potash–magnesium salt deposit. Perm : Berezniki, 2014. 130 p.
6. Procedural guidelines for selection of geomechanical parameters for shortwall coal mining. Saint-Petersburg : VNIMI, 2003. 30 p.
7. Interim operating procedure for pillar design for gently dipping ore bodies at a depth of 400 m and for sloping ore beds in the Zhezkazgan deposit. Kazakhmys Corporation. Almaty : Zhezkazgan, 1998. 158 p.
8. Protosenya A. G., Shokov A. N. 3D modeling of pillar parameters in ore mining with room-and-pillar method. Gornyi Zhurnal. 2015. No. 11. pp. 20–23. DOI: 10.17580/gzh.2015.11.04
9. Cherepov A. A., Shiryaev S. N., Kulak V. Yu. Justification of geomechanical parameters for room-and-pillar method of mining for thick gently dipping coal beds. GIAB. 2017. No. 9. pp. 161–169.
10. Napa-García G. F., Câmara T. R., Torres V. F. N. Optimization of room-and-pillar dimensions using automated numerical models. International Journal of Mining Science and Technology. 2019. Vol. 29, Iss. 5. pp. 797–801.
11. Hudeček V., Šancer J., Zubíček V., Golasowski J. Experience in the Adoption of Room & Pillar Mining Method in the Company OKD, a.s., Czech Republic. Journal of Mining Science. 2017. Vol. 53. pp. 99–108.
12. Ljunggren C. et al. An overview of rock stress measurement methods. Int. J. Rock. Mech. Min. Sci. 2003. Vol. 40. pp. 975–989.
13. Gray I., See L. The measurement and interpretation of in situ stress using an overcoring technique from surface. The 1st Canada-US Rock Mechanics Symposium. Taylor & Francis, Vancouver, 2007. pp. 721–727.
14. Baryakh A. A., Asanov V. A., Toksarov V. N., Gilev M. V. Evaluating the residual life of salt pillars. Journal of Mining Science. 1998. Vol. 34. pp. 14–20.
15. ASTM D4729-2008. Standard Test Method for In Situ Stress and Modulus of Deformation Using Flatjack Method. Annual Book of ASTM Standards D4729. pp. 1–7.
16. Shkuratnik V. L., Nikolenko P. V. Interpretation methodology of acoustic emission measurements, using a Kaiser effect for the deflected mode estimation of rock massif. Gornyi Zhurnal. 2012. No. 9. pp. 44–47.
17. Toksarov V., Asanov V., Evseev A., Beltukov N. Sedimentary Rock Stress Determination in boreholes using Kaiser effect. The 7th International Symposium on In-Situ Rock Stress : Symposium Proceedings. Tampere, Finland, 2016. pp. 501–508.
18. Voznesensky A. S., Shkuratnik V. L., Nabatov V. V., Kutkin Ya. O. Adjacent rock mass stability assessment by joint borehole measurements of acoustic and electromagnetic emission. GIAB. 2013. No. 8. pp. 64–70.
19. Baryakh A., Asanov V., Babkin A., Geghin A., Bruev A. Tool checking of salt pillars state for prediction of their residual time working. Prace Naukowe Instytutu Geotechniki i Hydrotechniki Politechniki Wroclawskiej. 2001, Vol. 73, No. 40, pp. 22–24.
20. Timofeev V. V. Monitoring software and hardware for rock mass hazards in the Khibiny apatite mines. Geodynamic Safety of Underground and Surface Mining Management : Proceedings of XII Interdepartmental Coordination Meeting. Apatity, 2003. pp. 168–190.
21. Evseev A., Asanov V., Lomakin I., Tsayukov A. Experimental and theoretical studies of undermined strata deformation during room and pillar mining. EUROCK 2018: Geomechanics and Geodynamics of Rock Masses. Taylor & Francis Group, London, 2018. pp. 985–990.
22. Waclawik P., Ptacek J., Konicek P., Kukutsch R., Nemcik J. Stress-state monitoring of coal pillars during room and pillar extraction. Journal of Sustainable Mining. 2016. Vol. 15. pp. 49–56.
23. Evseev A., Baryakh A., Butirin P. Remote Instrumental Monitoring of Interchamber Pillar Stability. Procedia Engineering. ISRM European Rock Mechanics Symposium EUROCK 2017. 2017. Vol. 191. pp. 962–966.
24. Baryakh A., Lobanov S., Lomakin I., Tsayukov A. Mathematical modelling of limit states for load bearing elements in roomand-pillar mining of saliferous rocks. EUROCK 2018: Geomechanics and Geodynamics of Rock Masses. Taylor & Francis Group, London, 2018. pp. 767–773.
25. Baryakh A. A., Samodelkina N. A. Water-tight stratum rupture under large-scale mining. Part II. Journal of Mining Science. 2012. Vol. 48, No. 6. pp. 954–961.
26. Manetti L., Steinmann, G. 3DeMoN ROBOVEC-integration of a new measuring instrument in an existing generic remote monitoring platform. Proceedings of the 7th International Symposium on Field Measurements in Geomechanics. FMGM, 2007. pp. 1–12.

Полный текст статьи Operational control of rib pillar stability
Назад