Journals →  Gornyi Zhurnal →  2020 →  #10 →  Back

PHYSICS OF ROCKS AND PROCESSES
ArticleName Engineering diagnostics of shaft lining in Gubkin Mine
DOI 10.17580/gzh.2020.10.05
ArticleAuthor Sergeev S. V., Vorobiev E. D., Ignatenko I. M., Zinchenko A. V.
ArticleAuthorData

GeoStroiMonitoring BelGU, Belgorod, Russia:
S. V. Sergeev, Professor, Doctor of Engineering Sciences, sergey.sergeev.v@mail.ru
E. D. Vorobiev, Director, Candidate of Engineering Sciences

 

Belgorod State University, Belgorod, Russia
I. M. Ignatenko, Director of the Institute of Earth Sciences, Candidate of Engineering Sciences

 

VIOGEM, Belgorod, Russia
A. V. Zinchenko, Senior Researcher

Abstract

Shafts in Gubkin Mine, KMAruda have been in operation since the late 1940s. The shafts are sunk in difficult hydrogeological conditions. At the present time, due to transition to deeper levels, deeper mine dumps are required. It is necessary to reinforce shaft lining in watered rocks. During long-term service of shaft 1, due to corrosion, thickness of liner plates and horizontal ribs has decreased by 1.5–2 and 3–5 mm, respectively (two-side corrosion). As a result, the load-bearing capacity of the tubbing has lowered by 5–7%. At the same time, the actual stresses are not higher than 22 MPa, which is 10 times less than the design compression resistance of gray cast iron as per Construction Code SP 16.13330.2017. Field studies have been performed in Gubkin Mine toward improvement of operating safety of shafts during mineral mining at deeper levels. Stress state diagnostics of lining in shaft 1 shows that the lining preserves its load-bearing capacity in all types of rocks. Thus, safe operation can be continued without extra expenses connected with the lining reinforcement. The field studies in the cage shaft show that pressure on the lining in frozen rocks is 1.5–2 times higher than the design values. It is recommended to continue the studies to estimate effects of possible rock displacements on the lining during further mining.

keywords Mine shaft, mixed-type support, concrete, tubbing, operational control, deformometer, stresses, strains, load on lining
References

1. Babayants G. M., Vertleyb L. K., Zhurin N. Ya. et al. Undeground mining of ferruginous quartzites. Moscow : Nedra, 1988. 168 p.
2. Kazikaev D. M., Kozyrev A. A., Kaspariyan E. V., Iofis M. A. Geomechanical behavior control in mineral mining : Teaching aid. Moscow : Gornaya kniga, 2016. 490 p.
3. Qing Yu, Kexin Yin, Jinrong Ma, Hideki Shimada. Vertical shaft support improvement studies by strata grouting at aquifer zone. Advances in Civil Engineering. 2018. Vol. 2018. ID 5365987. DOI: 10.1155/2018/5365987
4. Kazikaev D. M., Sergeev S. V. Diagnostics and monitoring of stressed state of vertical shafts’ timbering. Moscow : Gornaya kniga, 2011. 244 p.
5. Walton G., Kim E., Sinha S., Sturgis G., Berberick D. Investigation of shaft stability and anisotropic deformation in a deep shaft in Idaho, United States. International Journal of Rock Mechanic s and Mining Sciences. 2018. Vol. 105. pp. 160–171.
6. Guidelines on Field Studies in Mine Shafts Constructed in Difficult Geological Conditions. Belgorod : VIOGEM, 1985. 35 p.
7. Sentyabov S. V. Analysis and prediction of change in stress state of shaft lining in Gaisky mine. GIAB. 2018. No. 10. pp. 79–85.
8. Sammal A. S., Sergeev S. V., Antsiferov S. V., Deev P. V. Estimating concrete shaft lining applica tion field in zones of tectonic disturbance. Izvestiya Tulskogo gosudarstvennogo universiteta. Nauki o Zemle. 2018. No. 4. pp. 317–326.
9. Antsiferov S. V., Sammal A. S., Deev P. V. Stress-strain state estimation in multilayer support of vertical shafts, considering off-design cross-sectional deformation. Fundamentalnye i prikladnye voprosy gornykh nauk. 2017. Vol. 4, No. 2. pp. 19–25.
10. Xiaoming Sun, Gan Li, Chengwei Zhao, Yangyang Liu, Chengyu Miao. Investigation of Deep Mine Shaft Stability in Alternating Hard and Soft Rock Strata Using Three-Dimensional Numerical Modeling. Processes. 2019. Vol. 7, Iss. 1. DOI: 10.3390/pr7010002
11. Kunui Hong, Eunchol Han, Kwangsong Kang. Determination of geological strength index of jointed rock mass based on image processing. Journal of Rock Mechanics and Geotechnical Engineering. 2017. Vol. 9, Iss. 4. pp. 702–708.
12. Vlokh N. P. Stress state in lining made of cast iron tubbing. Metrostroy. 1990. No. 1. pp. 17–19.
13. Bulychev N. S. Mechanics of underground structures : Textbook. 2nd enlarged and revised edition. Moscow : Nedra, 1994. 382 p.
14. Sergeev S. V., Vorobev E. D., Zinchenko A. V. Engineering assessment of basic load-bearing structures in underground mines by deformation measurements using Stvol-V. Software State Registration Certificate No. 2016616080. Unified Register of Russian Programs for Computers and Databases. Registered: 06.06.2016.
15. Xiangdong Hu, Tao Fang, Jin Chen, Hui Ren, Wang Guo. A large-scale physical model test on frozen status in freeze-sealing pipe roof meth od for tunnel construction. Tunnelling and Underground Space Technology. 2018. Vol. 72. pp. 55–63.

Language of full-text russian
Full content Buy
Back