Journals →  Gornyi Zhurnal →  2019 →  #2 →  Back

EQUIPMENT AND MATERIALS
ArticleName Applicability of improved haul road surfacing in open pit kimberlite mines in Yakutia
DOI 10.17580/gzh.2019.02.15
ArticleAuthor Borisova A. A., Sokolova M. D., Zarovnyaev B. N., Akishev A. N.
ArticleAuthorData

Institute of Oil and Gas Problems, Siberian Branch, Russian Academy of Sciences, Yakutsk, Russia:

A. A. Borisova, Researcher, Candidate of Engineering Sciences
M. D. Sokolova, Acting Director, Doctor of Engineering Sciences

 

Ammosov North-Eastern Federal University, Yakutsk, Russia:
B. N. Zarovnyaev, Dean, Doctor of Engineering Sciences

 

Mirny Polytechnic Institute (Branch), Ammosov North-Eastern Federal University, Mirny, Russia:
A. N. Akishev, Associate Professor, Candidate of Engineering Sciences, AkishevAN@alrosa.ru

Abstract

Barely 10 % of haul roads in open pit mines in Yakutia have hard coating. The experience gained in operation of cement concrete topping on a spiral ramp road in Udachny OPM shows that this type surface is not always worthwhile in confine conditions of open pit kimberlite mines in Yakutia. It is most efficient to substitute cement concrete coating for modified asphalt concrete. Asphalt concrete ensures higher density, shear resistance, fracture toughness, wearability and roughness of road surface. Moreover, asphalt concrete features manufacturability and maintainability, which simplifies repair works and healing-up. A factor of no little significance is reliable gripping between asphalt concrete coating and machine tires, which is very important for road traffic safety. In the presented study, asphalt concrete was modified by rubber crumb and natural zeolite. Relatively low content of impurities, high heat stability and low cost of Yakutia’s zeolite-bearing rocks make natural zeolites a promising modifier for composites. Analysis of asphalt concrete characteristic shows that physical and mechanical properties of modified composites are higher than initial asphalt concrete has. It is observed that the strength, water resistance, heat endurance and freeze resistance grow while porosity and thermal sensitivity reduce. The modification to be efficient requires that haul road surfacing is implemented in compliance with all regulations of production procedures subject to agreement between the road topping structures, actual conditions of their operation, parameters of road construction machines, haul road characteristics and dump truck performance.
The study was implemented under State Contract No. 0377–2018–0001.

keywords Mine haul roads, kimberlite mine, rubber-modified bitumen, rubber crumb, zeolite, asphalt, mechanical activation
References

1. Nikolaev M. V., Grigorieva E. E., Gulyaev P. V. Assessment of risks influencing innovation activity of industrial enterprises (on example of diamond-brilliant complex). Eurasian Mining. 2016. No. 2. pp. 6–10. DOI: 10.17580/em.2016.02.02
2. Kurneva M. V., Vishnyakov J. D., Kiseleva S. P. Methodological approach to assessment of ecological and economic efficiency of reproduction of mineral raw material base of diamonds. Eurasian Mining. 2015. No. 2. pp. 21–25. DOI: 10.17580/em.2015.02.06
3. Basahel H., Mitri H. Application of rock mass classification systems to rock slope stability assessment: A case study. Journal of Rock Mechanics and Geotechnical Engineering. 2017. Vol. 9, Iss. 6. pp. 993–1009.
4. Preh A., Mitchell A., Hungr O., Kolenprat B. Stochastic analysis of rock fall dynamics on quarry slopes. International Journal of Rock Mechanics and Mining Sciences. 2015. Vol. 80. pp. 57–66.
5. Shabaev S. N. The factors which influence the bearing capacity of the fractured rocks of sedimentary origin. Izvestia Uralskogo gosudarstvennogo gornogo universiteta. 2018. No. 2(50). pp. 85–94.
6. Zyryanov I. V. Improvement of mechanical transport efficiency under extreme conditions of operation in open pit mines. Dissertation … of Doctor of Engineering Sciences. Saint-Petersburg, 2006. 378 p.
7. Kaufman W. W., Ault J. C. Design of Surface Mine Haulage Roads — A Manual : Information Circular 8758. Pittsburch, 2001. 49 p.
8. Baek J., Choi Y. A New Method for Haul Road Design in Open-Pit Mines to Support Efficient Truck Haulage Operations. Applied Sciences. 2017. Vol. 7, Iss. 7. DOI: 10.3390/app7070747

9. Thompson R., Hahn S., Pastor S. Development of mine haul road surfacing condition monitoring through digital image processing. Mining Engineering. 2015. Vol. 67, No. 9. pp. 34–45.
10. Zarovnyaev B. N., Akishev A. N., Kolganov V. F., Babaskin S. L., Shubin G. V. et al. Basic trends of improvement in deep open pit diamond mining. Natural Resources and Ecology in Russian Far East : International Scientific–Practical Forum. Khabarovsk, 2013. pp. 285–289.
11. Dukhovnyy G. S., Sachkova A. V. Efficiency of the application of rubber-binder in the construction of asphalt surfaces. Scientific Herald of the Voronezh State University of Architecture and Civil Engineering. Construction and Architecture. 2014. No. 2(34). pp. 19–23.
12. Shestakov N. I., Urkhanova L. A., Buyantuev S. L., Semenov A. P., Smirnyagina N. N. Asphalt concreate using carbon nanomodifiers. Bulletin of BSTU named after V. G. Shukhov. 2015. No. 6. pp. 21–24.
13. Gorshkov E. V., Tarasov A. P. Wheel and road surface grip coefficient in open pit mines. GIAB. 2008. Special issue 8. pp. 330–343.
14. Sokolova M. D., Khristoforova A. A., Morova L. Ya., Rubanov P. A. Method of preparing rubber mixture. Patent RF, No. 2383562. Applied: заявл. 31.03.2008. Published: 10.03.2010. Bulletin No. 7.
15. Gokhman L. M. Bitumen, polymer-bitumen binders, asphalt concrete. Moscow : EKON-INFORM, 2008. 117 p.
16. Kiselev V. P., Efremov A. A., Bugaenko M. B., Gurev D. L., Kemenev N. V., Filimonov V. S. Estimation of the adhesive and cohesive properties of the modified road bitumen. Vestnik of TSUAB. 2010. No. 4. pp. 129–138.

Language of full-text russian
Full content Buy
Back