Journals →  Gornyi Zhurnal →  2019 →  #1 →  Back

DESIGNING AND MINING-CONSTRUCTIONS WORK
ArticleName Pilot trials of high-tensile MINAX mesh as surface support in Kirov and Taimyr mines
DOI 10.17580/gzh.2019.01.05
ArticleAuthor Barinov A. Yu., Eremenko V. A., Filatov A. G., Bazin A. A.
ArticleAuthorData

GEOBRUGG, Moscow, Russia:

A. Yu. Barinov, Chief Executive Officer, Candidate of Geographical Sciences
A. G. Filatov, Managing Director

College of Mining, NUST MISIS, Moscow, Russia:

V. A. Eremenko, Director of Research Center for Applied Geomechanics and Convergent Technologies in Mining, Doctor of Engineering Sciences, Professor of the Russian Academy of Sciences, prof.eremenko@gmail.com


Polar Division, Nornickel, Norilsk, Russia:

A. A. Bazin, Leading Specialist

Abstract

Reinforcement of underground excavations is the key mission of any support meant for reducing risk of rock falls. Two basic functions of rock surface support in mines are load distribution in the system of rock bolts and retention of small rock falls (sags) between rock bolts. Rock mass is reinforced thereat, and resistance of rocks to failure and loosening (weakening) is improved. Mines all over the world apply surface supports but down to date there are no regulated guidelines on the most efficient support design for specific conditions, for instance, deformable and rockburst-hazardous rocks. A ground support system is selected based on the analyses of safety and cost factors, namely, load-bearing capacity, operating availability, expediency, work content of installation, loads (static or dynamic), etc. This article describes pilot trials of high-tensile steel wire mesh MINAX with wire diameter of 3 and 4 mm in rockburst-hazardous mines Kirov and Taimyr. Ground support design under conditions of high deformability and rockburst hazard is implemented as selection of optimum parameters with regard to energy absorption capacity per unit area of support. The research aimed to evaluate: MINAX mesh efficiency on the backs and side walls of excavations; work content and rate of MINAX mesh installation using special nozzle MESHA and Sandvik DS-411 rock reinforcement drillrig; effect of blasting on the mesh integrity; MINAX corrosion stability in mines; expediency and economic effect of the mesh. The effect of the mesh application in the pilot tests on three sites in two underground mines was beneficial: no rupture, separation or tearing-off of the mesh was observed after blasting; flexible chain links were insensitive to blast waves; the yielding and high-tensile mesh had high energy absorption capacity; light-weight MINAX mesh was easy to support and cut into separate sheets by reinforced scissors; the mesh was easily shotcreted; it was galvanized to protect from corrosion; the tensile strength of the wire mesh, for instance, MINAX 80/4, reached 2.3 t, which was two times higher than the ultimate tensile strength of the weld wire mesh with diameter of 5.6 mm. It is recommended to use high-tensile mesh MINAX in permanent, development, temporary and stoping excavations in highly stressed or weakened block rock mass in underground mining of ore deposits in the Norilsk Region, Yakutia, Khabarovsk Territory, Gornaya Shoria, Khakassia, Kola Peninsula, Ural, etc.

keywords Mine, stope, surface support, high-tensile mesh MINAX, rock bolt, shotcrete
References

1. Kaiser, P. K., McCreath, D. R., Tannant, D. D. Canadian Rock burst Support Handbook. CAMIRO, Sudbury, 1996. 324 p.
2. Louchnikov V. N., Eremenko V. A., Sandy M. P., Kosyreva M. A. Support Design for Mines Exposed to Rockburst Hazard. Journal of Mining Science. 2017. Vol. 53, Iss. 3. pp. 504–512.
3. Neugomonov S. S., Volkov P. V., Zhirnov A. A. Tunnel support in weak rocks using self-fastening rock bolts SZA. Gornyi Zhurnal. 2018. No. 2. pp. 31–34. DOI: 10.17580/gzh.2018.02.04
4. Kalmykov V. N., Volkov P. V., Latkin V. V. Evaluation of chemically bonded rock bolt support in pilot trials in Saf’yanov mine. Aktualnye problemy gornogo dela. 2016. No. 2. pp. 27–35.
5. Kalmykov V. N., Latkin V. V., Zubkov A. A., Neugomonov S. S., Volkov P. V., Technological feature of reinforced combination-type ground support installation in underground mines. GIAB. 2015. No. 4. Special issue 15. pp. 63–69.
6. Bucher R., Cala M., Zimmermann A., Balg C., Roth A. Large scale field tests of high‐tensile steel wire mesh in combination with dynamic rock bolts subjected to rock burst loading. 7th International Symposium on Ground Support in Mining and Underground construction. Perth, 2013.
7. Potvin Y., Wesseloo J. Towards an understanding of dynamic demand on ground support. Journal of the Southern African Institute of Mining and Metallurgy. 2013. Vol. 113, No. 12. pp. 913–922.
8. Player J. R., Morton E. C., Thompson A. G., Villaescusa E. Static and dynamic testing of steel wire mesh for mining applications of rock surface support. 6th International Symposium on Ground Support in Mining and Civil Engineering Construction. SAIMM, 2008.
9. Balg C., Roduner A. Geobrugg AG: ground support applications. Int. Ground Support Conference. AGH University. Lungern, 2013.
10. Louchnikov V. N., Eremenko V. A., Sandy M. P. Ground support liners for underground mines: energy absorption capacities and costs. Eurasian Mining. 2014. No. 1. pp. 54–62.
11. Potvin Y., Wesseloo J., Heal D. An interpretation of ground support capacity submitted to dynamic loading. Mining Technology. 2010. Vol. 119, No. 4. pp. 233–245.
12. Galchenko Yu. P., Eremenko V. A., Myaskov A. V., Kosyreva M. A. Solution of geoecological problems in underground mining of deep iron ore deposits. Eurasian Mining. 2018. No. 1. pp. 35–40. DOI: 10.17580/em.2018.01.08
13. Myaskov A. V. Current ecological and economical problems of subsoil management. GIAB. 2014. No. 2. pp. 157–160.
14. Timonin V. V., Kondratenko A. S. Process and measuring equipment transport in uncased boreholes. Journal of Mining Science. 2015. Vol. 51, Iss. 5. pp. 1056–1061.
15. Paul A., Murthy V. M. S. R., Prakash A., Singh A. K. Estimation of rock load in development workings of underground coal mines. A modified RMR approach. Current Science. 2018. Vol. 114(10). pp. 2167–2174.
16. Souley M., Renaud V., Al Heib M., Lahaie, F., Nyström A. Numerical investigation of the development of the excavation damaged zone around a deep polymetallic ore mine. International Journal of Rock Mechanics and Mining Sciences. 2018. Vol. 106. pp. 165–175.

Language of full-text russian
Full content Buy
Back