Журналы →  Non-ferrous Мetals →  2017 →  №1 →  Назад

AUTOMATION
Название Problems of analysis of thermalphysic processes in a reaction zone of electrothermal reactor
DOI 10.17580/nfm.2017.01.08
Автор Panchenko S. V., Dli M. I., Bobkov V. I., Panchenko D. S.
Информация об авторе

Branch of the National Research University “Moscow Power Engineering Institute”, Smolensk, Russia:

S. V. Panchenko, Professor, Chair of Physics
M. I. Dli, Professor, Head of a Chair of Management and Information Technologies in Economics, e-mail: midli@mail.ru
V. I. Bobkov, Assistant Professor, Chair of Mathematics
D. S. Panchenko, Engineer

Реферат

Analyzed are thermalphysic processes in an ore-smelting electrothermal reactor, which is a reaction bulk with different phase composition, where mechanisms of turbulent energy transfer act together with the physical-chemical target transformations proceeding. Chemical reduction processes proceed when isolating the gas phase, bubbling the melt and intensifying processes of the product making. Independent problems of analysis of thermalphysic processes in a near-electrode crucible reaction zone based on a two-dimensional model are considered. Analytical solutions for describing thermalphysic processes in a reaction zone which characterize conditions of the target product manufacturing are obtained. There are cited the data which define distributions of the Joule heat emission flux density for different modes as well as distribution of temperatures depending on different unit power values. Obtained are analytical solutions for energy metabolism problem under the change of phase condition in a slag tipping mode and equations of diffusion of the reagent being reduced in the area of physical-chemical transformations proceeding. Skull layer formation task is solved. Obtained solutions practically describe all the collection of processes in a reaction zone and can serve as a starting point for numerical approaches to analysis of reduction reactors operating modes. It is discovered that target processes are localized in a nearelectrode zone with formation of the crucibles practically unrelated with each other. However, the energy transfer processes broaden an effective area of reactions and should be taken into account during designing and mode control. Neglecting heat efficiency may introduce considerable errors in analysis of the modes.

This work was supported by the State Task of the Ministry of Education and Science of the Russian Federation (the basic part, project No. 13.9619.2017/BCh).

Ключевые слова Electrothermal reactor, thermalphysic process, mathematical model, mathematical physics equations, power distribution of the Joule heat sources, temperature distribution, concentration of reagent distribution over reactor volume, skull layer, near-electrode processes localization
Библиографический список

1. Chumakov Yu. A., Mazmanyan V. A., Rumyantsev D. V., Tsemekhman L. Sh., Egorov P. A. Analysis of ore-thermal furnace operation at “Pechenganickel” combine under conditions of changing of charge composition. Tsvetnye Metally. 2014. No. 1. pp. 16–21.
2. Strunskiy B. M. Ore thermal smelting furnaces. Moscow : Metallurgiya, 1972. 368 p.
3. Kondrashev V. P., Mironov Yu. M., Kozlov A. I. et al. Investigation of operating modes of industrial electric furnaces for the production of silicon carbide. In the collection: Orerestoring electric furnaces. Moscow : Energoatomizdat, 1988. pp. 32–38.
4. Panchenko S. V., Stoyak V. V., Panchenko A. I. Pulse thermal impact on reacting dense bed. Khimicheskaya fizika. 1990. Vol. 9, No. 12. pp. 1689–1692.
5. Bogatyrev A. F., Panchenko S. V., Stoyak V. V., Shister A. G. Modeling and optimization of thermal-technological processes. Alma-Ata : KazPTI, 1989. 116 p.
6. Meshalkin V. P., Panchenko S. V., Panchenko D. S., Menshikov V. V., Kazak A. S. Computer-aided simulation of heat- and mass-transfer processes in an ore-reduction electrothermal reactor. Teoreticheskie osnovy khimicheskoy tekhnologii. 2015. Vol. 49, No. 5. pp. 1–7.
7. Panchenko S. V., Meshalkin V. P., Dli M. I., Borisov V. V. Computer-visual model of thermophysical processes in electrothermal reactor. Tsvetnye Metally. 2015. No. 4. pp. 55– 60.
8. Hariharan M., Rafi K. Mohd., Raghavan D. Modelling of calcium carbid furnace. Bulletin of Electrochemistry. March 1990. 6(3). pp. 298–301.
9. Eksteen J., Frank S., Reuter M. Dynamic structures in variance based data reconciliation adjustments for a chromite smelting furnace. Minerals Engineering. 2004. 15 (11). 931–943.
10. Yang Y., Xiao Y., Reuter M. Analysis of transport phenomena in submerged arc furnace for ferrochrome production. International Ferroalloy Congress, SAIMM, 2004. pp. 15–25.
11. Scheepers E., Adema A. T., Yang Y., Reuter M. A. The development of a CFD model of a submerged arc furnace for phosphorus production. Minerals Engineering. 2006. Vol. 19, P. 1115–1125.
12. Scheepers E., Yang Y., Adema A. T., Boom R., Reu ter M. A. Process modeling and optimization of a submerged arc furnace for phosphorus production. Metallurgical and Materials Transactions B. 2010. Vol. 41, No. 5. p. 990.
13. Panchenko S. V. Thermal physics of heterogeneous reaction processes during the release of gaseous phase products. Collection of proceedings of International scientific-technical conference “Energetics, informatics, innovations-2015”. Smolensk : Universum, 2015. Vol. 1. pp. 137–141.
14. Panchenko S. V., Panchenko D. S., Glebova N. B. Transfer processes in heterogeneous reduction reactors. Teoreticheskie osnovy khimicheskoy tekhnologii. 2004. Vol. 38, No. 6. pp. 1–5.
15. Dantsis Ya. B., Ershov V. A., Zhilov G. M. et al. Electrochemical processes of chemical technology. Ed. V. A. Ershov. Leningrad : Khimiya, 1984. 464 p.
16. Panchenko S. V., Shirokikh T. V. Thermal hydraulics of moving dispersive layer of process units. Teoreticheskie osnovy khimicheskoy tekhnologii. 2016. Vol. 50, No. 2. pp. 1–8.

Полный текст статьи Получить
Назад